Installing a new version of virtualmin causes a network card configuration error

3 posts / 0 new
Last post
#1 Mon, 08/05/2019 - 21:19
ikirin

Installing a new version of virtualmin causes a network card configuration error

Virtualmin could not work out the default IPv4 address for virtual servers on your system. You will need to update either the Network interface for virtual addresses or Default virtual server IP address fields on the module configuration page.

.. your system is not ready for use by Virtualmin.

Network Interfaces

Active Now Interfaces listed in this table are currently active on the system. In most cases, you should edit them under the Activated at Boot tab.

Select all. | Invert selection. | Add a new interface. Name Type IPv4 address Netmask IPv6 address Status

eth0 Ethernet 1000Mb/s No address configured None fe80::225:10ff:fed2:756a Up eth1 Ethernet 1000Mb/s No address configured None fe80::225:10ff:fed2:756b Up lo Loopback 127.0.0.1 255.0.0.0 ::1 Up

Select all. | Invert selection. | Add a new interface.

Network Interfaces

Activated at Boot Interfaces listed in this table will be activated when the system boots up, and will generally be active now too.

Select all. | Invert selection. | Add a new interface. | Add a new bonding Interface. | Add a new bridge. | Add a new address range. Name Type IPv4 address Netmask IPv6 address Active

eth0 Ethernet 108.139.196.26 255.255.255.248 Yes eth1 Ethernet From DHCP From DHCP From IPv6 discovery Yes lo Loopback 127.0.0.1 255.0.0.0 Yes
Tue, 08/06/2019 - 01:07
suskozaver

In Virtualmin, click System Settings, Virtualmin Configuration, Networking Settings.

Check Network interface for virtual addresses, if set to Detect automatically, try changing it to eth0. Also for default virtual server IPv4 address, if set from networking interface, change it to custom field and enter your IP.

Tue, 08/06/2019 - 22:41 (Reply to #2)
ikirin

My server NIC error is the same as this problem https://www.virtualmin.com/node/66739

Topic locked